Mar 20, 5, Posts. #3 Dec 21, If you have access to a press, whether garage or a friend, do the work your self, the bushings weren't much, the ball joint should hopefully transfer over. Unless you find a good deal on the replacement control arm, and it would come with a new BJ, as well. Durango FM 50mm, PS Headers, K&N FIPK, Rancho Estimated Reading Time: 2 mins. RE: upper control arm bushing removal IP: Logged Message: Torch?
Right. The Energy upper bushings must reuse the existing shell and there's no need to press the existing shells out. Drill through the rubber, around the inner bushing,and then just pick out pieces with a packing hook, pick, and/or cotter pin puller. The center rod.
What I've found to be the easiest way to remove the lower control arm bushings that are pressed into the FRAME of a x4. 2wd trucks have both l. Oct 05, Joined Apr 9. Posts. Discussion Starter #1 Sep 17, I'm in the middle of installing a 6" fabtech Lift kit on my 4x4 The rear control arm bushings that are in the frame need to be removed.
I have a 2 jaw puller that I was trying to use to push the bushing thru but it just pushes the sleeve that's mounted in the.
Sep 22, Description. Energy Suspension HYPER-FLEX polyurethane front control arm bushings for your ''09 Dodge Ram / 4WD truck do not rot or deteriorate from exposure to oils and undertruck chemicals or atmospheric conditions like smog and ozone. Unlike O.E.M. rubber, HYPER-FLEX components will not break down and deteriorate causing mushy.