Repeat steps 4 through 8 until you reach the right side of the stump. Return the grinder to the left side of the stump, lower it, and repeat steps 3 through 10 until you have ground the stump into the ground.
Note: To contain the chips, you may need to stop the grinder and move the chip guard up as you move the grinder bushfall.buzz: 79 cm (31 inches). Some dedicated stump grinders are over-complicated. Not the Toro STX. Its patented Toro Dingo TX-style control system has two simple levers that are simple to learn, master and use. Combine these easy-to-use controls with tracks and transport speeds exceeding 4. 12 tungsten, carbide tipped teeth handle the most difficult stumps.
Positioned between handle and frame reduces vibration resulting in less operator fatigue. Equates to less “muscling” machine while cutting. Allows for easy compact transport in back of SUV, car trunk, or mini van. Durable clutch to handle abuse of stump impact. Back up the machine, position the grinder to the side of the front of the stump, and lower it to about 2 cm (1 inch) below the surface.
Repeat steps 4 through 7 until the stump is ground away. If there are any large roots to be ground, position the grinder over each root and use the traction control and grinder control to move the grinder Height: cm ( inches).
Move the machine to the front of the stump and engage the parking brake. Move throttle up to the ENGAGE position. The cutting wheel will begin rotating. Swing the cutting wheel to one side (Figure 10), then lower it approximately 1 to cm (1/2 to 1 inch) into the front-top corner of the bushfall.buzzg Depth: 30 cm (12 inches).
We sell new OEM (original equipment manufacturer) Toro Stump Grinder parts. Purchase parts using our secure checkout and have these parts delivered to your doorstep. Choose the model from the navigation menu above and you will be directed to our parts diagram page.
Search through our diagram pages to find the part or parts you need. Start the engine, raise the grinder, set the throttle lever to the FAST position, and move the machine to the stump to be ground. Use the grinder control lever and the traction control to position the grinder to the side of the front of the stump.